IMITATION HARDWOOD, DESK DRAWER PULLS, ,5-5/8" wide x 2-1/4" high, 1-1/8" Projection, Not Tapped or Drilled, This walnut looking hardware is made of a lightweight resin material. An exact copy of an original carved wood pull, the process picks up the grain, of the wood in detail. Once installed it looks like real carved walnut. INSTALLATION INSTRUCTIONS, Front mount: Scuff sand the back, apply glue, position and clamp or weight until glue dries. If Clamping or weighting is not possible, hold in place by nailing with brads Pre-drill nail holes. Counter sink brads and fill with putty. Rear Mount: Pre-drill proper size holes and attach from back with screws.
Antique Hardware & Supplies